tangency
英
美
网络 切线连续; 接触; 相切; 切向参考; 切矢连续
复数：tangencies
英英释义
noun
- (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
- they forget to solder the contacts
- the state of being tangent
双语例句
- The paper takes teaching environment as point of tangency, gives an thorough analysis on the constructing element of teaching environment and educational equipment as well as their mutual relations.
教育技术装备是教育体系中不可或缺的重要组成部分，是发展大教育的要素之一，也是推动教育信息化的重要力量。 - Then everyone should be holding the tangency portfolio.
所有人都应该持有切线投资组合。 - The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切，在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法，用VISUALLISP语言编程建立了圆弧连接通用绘图程序。 - Now, he's using a much longer sample than I did, so he's not going to get this tangency portfolio that I did.
他的样本跨度比我的要大多了，所以他得出的切线资产组合会和我的不同。 - With the Lagrange multiplier method, the minimum distance of the center of a circle and a quadric surface was provided and the tangency condition of curve and surface was given.
利用拉格朗日乘子法求解二次曲线和二次曲面之间的最小距离，给出了曲线与曲面相切的条件。 - Concepts about bridge node and loop tangency are proposed. The principle of the loop shrinkage of the signal flow graphs is deduced from the point of view of the equivalence of node split.
提出了桥结点、环路相切概念，从结点分裂的等价观点出发，导出了信号流图中环路收缩的原理。 - According to certain rules, points of tangency or intersection with obstacle area are selected as the key points to cell decomposition by sweeping the target area with a tangent that shifts length timely.
变长切线法通过切线扫掠目标区域，按一定规则选取由切线与障碍区产生的切点或交点作为关键点来进行单元分解。 - Their point of tangency is called the pitch point, and since it lies on the line of centers, it is the only point at which the tooth profiles have pure rolling contact.
大小齿轮的接触点称为节点，由于节点位于中心线上，因此节点是齿形轮廓线上唯一做纯滚动接触的点。 - Then finally, the final step is to find what is the tangency line that goes through the riskless rate.
在最后，最终的步骤是找出一条，穿过无风险收益率的切线。 - Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
通过对NURBS曲线的控制顶点扰动，采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征，并讨论了多点几何特征同时修改的情况。