slenderness

英 [ˈslɛndənəs]

美 [ˈslɛndərnəs]

网络  细长度; 长细比; 纤细; 名词; 细长

BNC.40473 / COCA.40756

英英释义

noun

• the property of an attractively thin person
  Synonym:slightnessslimness
• relatively small dimension through an object as opposed to its length or width
  1. the tenuity of a hair
  2. the thinness of a rope
  Synonym:thinnesstenuity
• the quality of being slight or inadequate
  1. he knew the slenderness of my wallet
  2. the slenderness of the chances that anything would be done
  3. the slenderness of the evidence

双语例句

• The calculation model of cable tension tested by frequency method for tied-arch bridge is analysed, the effects law of slenderness ratio on calculation precision are also analysed.
  对基于频率法测试系杆拱桥吊杆索力的计算模型的选用进行了研究，重点分析了吊杆长细比对模型计算精度的影响规律。
• Laws of bearing capacity and mechanical property affected by slenderness ratio and load eccentricity ratio were investigated.
  根据试验结果，总结了长细比、偏心率对试件承载力和力学性能的影响规律。
• Some kinds of Newtons theory of collision methods is extended to calculate the supersonic and hypersonic missiles with large slenderness ratio.
  将牛顿碰撞类方法推广应用于超、高超声速细长体导弹的气动特性预测。
• It is shown that the nonlinear frequency ratio increases with the vibration amplitude and the slenderness ratio.
  计算结果表明非线性频率与线性频率之比随振动幅值的增大和梁长细比的增大而增大；
• How to improve the designing methods of die used for bigger slenderness ratio half hollow aluminium profile are expounded.
  阐述了如何提高舌比较大的半空心铝型材模具寿命的设计方案，即将半空心型材模具设计成整体分流模的形式。
• Bounds slenderness ratio among axial compression short columns, middle long columns and long columns were determined.
  确定了钢管煤矸石混凝土轴心受压短柱与中长柱以及中长柱与长柱的界限长细比；
• Research on Determining slenderness ratio of members of superhigh voltage transmission steel tubular towers
  特高压钢管输电塔构件长细比取值研究
• Based on model experiment and simulated experiment, the formula of equivalent slenderness ratio was established.
  在模型试验和仿真试验的基础上，提出了单边连接高强角钢等效长细比公式。
• According to the slenderness ratio and the maximum windward area, four experiments are designed.
  按不同的长细比和不同的最大迎风面积设计了四个实验。
• This article presents a unified analysis of the limiting slenderness of plate elements of compression members with three commonly used sections.
  本文统一分析了轴心压杆三种常用截面的板件宽厚比限值。